| |
|
|
SAE F-1
is suitable for oil retention in installations
where the felt is not compressed for feeding
low viscosity or light oil, and where unusual
strength and
hardness are required washers, bushings, wicks,
door bumpers, polishing blocks and parts where
wear and
resistance to abrasion are required, are typical
uses.
SAE
F-50 is recomended for ball
and roller bearing oil retainer washers and
small dust excluiding washer. Also for mechanical
purposes where an accurate, thin, smooth high
grade felt is required.
SAE F-2 and F-3 are recommended
for vibration mountings and the same general
purposes and SAE F-1 but where a felt of slightly
lower quality is safisfactory.
SAE
F-51 is recommended for the
same general uses as F-50 but in installations
where tolerances and lenght of life are not
as important. Also for thin cut parts such
as gaskets and liners. |
|
SAE F-5, F-6
and F-7 are recommende for
dust shields, wipers, grease retainer washers,
vibration mounts, and in uses where a resilient
felt is required.
SAE
F-55 is recommended for anti-squeak
strips and for lining when cemented to fiber
board or metal panels.
SAE
F-10, F-11 and F-12 are recommended
for grease and oil retention where the felt
is confined and compressed in assembly. Also
recommended for dust shields under less severe
operating conditions where F-5, F-6 and F-7
are not required.
SAE
F-13 is recommended for sound
deadening, chassis strips, spacers, dust shields,
pedal, pads, dash liners, and for mechanical
purposes where abrasion and wear are not important
factors. |
| |
|
|
| VIEW
SAE SPECIFICATION |
